I Have My Barton 2500+

[bigdawgfoxx]

By the way...has anyone seen VB latley? He hasnt been here in forever

[_John_Lennon_]

Originally posted by Virtualbody1234@29 February 2004 - 19:27

Has anyone read my Posts?????????????

Yes VB we have.

I am just stating what you said in a different way, and in my opinion, in hopes he will take my advice as well.

[Virtualbody1234]

The different way is that it's a known issue with that board.

[Lamsey]

You know what I think the problem is?





Call it a long shot, but I think his motherboard is reporting the temperatures wrong.

[clocker]

You could be right Lamsey.

On the other hand, maybe the board is reporting the wrong temps.

[Virtualbody1234]

[clocker]

Actually, I'm surprised that VB didn't catch this....

[Dray_04]

lol....


ahhhhhhhhhhhhhh just hadda 25min shower..

i think the mobo is reading the wrong temps ay...
















nah but check this out... i took out the 2500 chip because i was scared i wud fuck it up already, and i put my old 2000 in....

..and the temps for the CPU and Case are 30 / 29 degrees respectively.

huh? is it still reading wrong.... WTF!!!!!!!!!!!

[bigdawgfoxx]

hm...those temps seem right..wierd

that would show that the board is NOT reporting the wrong temps..

The only person dumb enough to say the board isnt reporting the right temps would be VB...well nvm..he aint even that dumb.. haha

[tesco]

try actually feeling the heatsync and if it feels extremely hot then its higher than 30 but if its not too hot, with the air going by its actually just warm then it is probably around 30.

before i thought u meant that u used the same heatsync from teh 2000 processor for the 2500 and didnt put new thermal paste on but it was a new heatsync and new thermal paste right?

btw, dont try to put the 2500 back in now until you have gotten some arctic silver as once it has been removed it wont have as good of a contact and will run a llot higher.