rTorrent - How to have multiple move on complete commands?

[yraverage_geek]

Hi all,

I've recently setup a small seedbox for myself and so far the experience has been amazing. Who knew you could reach 100% in a couple of hours :)

I've been a little bit stuck however on my rtorrent config file. Based on the wiki, I setup a watch directory condition like so:


schedule = watch_directory_1,10,10,"load_start_verbose=~/torrent_downloads/tv_shows/META/*.torrent, view.set_visible=view_tv_shows, d.set_custom1=~/torrent_downloads/tv_shows/completed/"

I also setup a "move on complete" command. Since I'm running 0.8.4, the old syntax is no longer supported and after some searching around I came up with this:

system.method.set_key = event.download.finished,move_complete,"d.set_directory=$d.get_custom1= ;execute=mv,-u,$d.get_base_path=,$d.get_custom1="

The thing is, that command seems to be a global parameter, so every job triggers it. Problem is that most files don't have a "custom1" tag attached, so the path info inside rtorrent gets thoroughly screwed up :(

I would be very grateful is someone could tell me how to have more than 1 "move on complete" command in the same rtorrent.rc file - one for regular downloads and one for watch jobs.

[yraverage_geek]

Well I finally asked around on the libtorrent mailing list. Based on some tips from the folks there and a little bit of experimentation, I came up with a working command-set:


system.method.set_key = event.download.finished,check_custom1,"branch=d.get_custom1=,d.set_custom2=$d.get_custom1=,d.set_custom2=~/downloads/completed/"
system.method.set_key = event.download.finished,move_complete,"d.set_directory=$d.get_custom2= ;execute=mv,-u,$d.get_base_path=,$d.get_custom2="

The main thing to note is the use of a 2nd custom variable. Hope this helps someone.