ot_2003
11-02-2003, 01:23 PM
Sorry if an answer to this has been posted... I searched... without luck :P
When downloading a file with K++ 2.4.3, it connects and d/ls perfectly.... UNTIL it seems to forget where it's up to and starts again from 0%. This doesn't often happen with small files (eg 10mb) as they'll almost always complete before the problem occurs. But with 700mb files, it might happily download for sevreal hours and then at 450mb just 'forget' where it's up to and start again from 0%!!! grr. :angry:
Same problem happened with K++ 2.4.2 and previous versions, under WinXP, on multiple installations.
Is this a known issue?? Is there a way to fix it? If not, is it possible to back up my dat files as i go along by copying them - if so which files should i copy?
When downloading a file with K++ 2.4.3, it connects and d/ls perfectly.... UNTIL it seems to forget where it's up to and starts again from 0%. This doesn't often happen with small files (eg 10mb) as they'll almost always complete before the problem occurs. But with 700mb files, it might happily download for sevreal hours and then at 450mb just 'forget' where it's up to and start again from 0%!!! grr. :angry:
Same problem happened with K++ 2.4.2 and previous versions, under WinXP, on multiple installations.
Is this a known issue?? Is there a way to fix it? If not, is it possible to back up my dat files as i go along by copying them - if so which files should i copy?