sandman_1
10-13-2011, 01:11 PM
Got a Netgear WPN824N router and am able to Telnet into it, finally. I have very liittle knowledge of Linux and the commands and such. Anyway I tried adding a static ARP entry using the arp command like this
arp -i br0 192.168.1.x 00:00:00:00:00:00
However that didn't work. I am trying to get WOL to work over WAN and read that this was the only way to do it.
I was reading that I should add it to the ect/ethers file but I don't see that file nor know how to add it. Here is what is in that dir.
ath hotplug.d preinit
ath.orig hotplug2-init.rules preinit.arch
banner icon.ico profile
config init.d protocols
crontabs inittab rc.common
dnsmasq.conf ipkg.conf rc.d
email large.ico resolv.conf
ethertypes lld2d.conf shells
functions.sh modules.d sysctl.conf
group mtab wpa2
hostapd.conf passwd wpa2.orig
hosts ppp
arp -i br0 192.168.1.x 00:00:00:00:00:00
However that didn't work. I am trying to get WOL to work over WAN and read that this was the only way to do it.
I was reading that I should add it to the ect/ethers file but I don't see that file nor know how to add it. Here is what is in that dir.
ath hotplug.d preinit
ath.orig hotplug2-init.rules preinit.arch
banner icon.ico profile
config init.d protocols
crontabs inittab rc.common
dnsmasq.conf ipkg.conf rc.d
email large.ico resolv.conf
ethertypes lld2d.conf shells
functions.sh modules.d sysctl.conf
group mtab wpa2
hostapd.conf passwd wpa2.orig
hosts ppp