Everytime I use KL, and people is uploading, and I'm dowloading, my internet connection gets very slow, I can't open a webpage as I normally do without K running.
Printable View
Everytime I use KL, and people is uploading, and I'm dowloading, my internet connection gets very slow, I can't open a webpage as I normally do without K running.
you only have a certain amount of bandwidth available on your internet connection
downloading and uploading on k-lite uses bandwidth
If you're on a 56k, that's to be expected -- KL++ basically takes a T-1 line and drains it dry if you let it!
Anyhow, you should ALWAYS limit KL++'s upload bandwidth (under tools, advanced, bandwidth in kilobits) to something LESS than the maximum your connection can sustain.
For broadband connections, 64 kilobits (8 KB/sec) is a good start.
Run with that for awhile and see if it goes faster.
ALSO, you may have been using the same ip for too long and now have 1,000's of people on Kazaa/KL++ retrying their download FROM you. This also tends to cause slowdowns -- EVEN WHEN NOT RUNNING KL++!
my connection is broadband.
How do I change my IP?
it may change if you disconnect and reconnect from the internetQuote:
Originally posted by imation@30 December 2003 - 04:37
my connection is broadband.
How do I change my IP?
check your ip from http://www.whatismyip.com
Than disconnect and reconnect and check it again to see if it changes, and if it does no need to worry. Most ISP's have random IP's set when you connect and stays fixed until you disconnect.
you could use net limiter to limit the amount of bandwith used by kazaa
If within 15 seconds of starting KL++, you've had 20+ people try to download from you... your ip address hasn't (and probably DOESN'T) change.
If that's the case, you NEED to drain off the excessive uploads by turning off file sharing AFTER filling up all your upload slots.
Then turn file sharing back on once most of your upload finish/fail/cancel.
Repeat as needed.
You may have been getting 100's of new upload requests every HOUR, so if you've been using KL++ for awhile don't expect this problem to solve itself even in a couple days!