Printable View
I'm in the uk with an ntl 10mbps connection, the area I live in can only get analogue cable tv as the digital stuff hasn't been added to the exchange yet. What I'm wondering is if i put a coaxial splitter in the coaxial cable before it gets to my modem and run teh second line into my tv card will it be able to tune in and pick up anything from the cable channels? Also no I don't have a cable tv account.
How would you be able to pick up cable w/o a cable account?? :blink:
Perhaps it's different in the UK. :unsure:
It's kinda my main point? my card does have a cable tuner that picks up some stuff but I don't know if they have full filters on the lines here or if you just need the right equipment for them.
The best way to find out is to disconnect it from your modem and try it on your tuner card.
You MAY be able to pick up a few of the freeview channels on the old analogue network, until the shut off in you area occurs
I think I read somewhere that that would work. Try it out.
Just a thought when looking at my cable line. It looks to my likes its ct100 coaxial, the same kinda stuff that sky use for their boxes. This has a screw connection instead of a normal male/female coaxial, but my tv card only has the old male/female type, any ideas if it would still be ok if i just got an adapter or is the signal going to be alll fecked when it gets to my card?
I got lucky with free cable for a very long time. The town I live in has its own stupid cable channel with news about whats happening that the cable company's had to provide, so just by hooking up a box I got all the channels free...
http://forums.ntlhell.co.uk/
Try asking here :)
it works for me, Just tried it out last night- get a spliter and connect one side to the modem, then I think you can get a converter from the screw connection to the male/female so you can connect to the tv card. I would just get the converter for now and try plugging into the tv card and seeing if your service works that way.
It might work fine it the USA but i need to know if this is likely to work with ntl in the UK as they only send the signal down the line for what you pay for normally.
I don't think it matters location wise, although the company that sends it out would matter. I know from experence that with bresnen, if you hook the cable up to a tv you get basic cable, even if you are only paying for internet.
just try it. what will it cost you? a few bucks for the splitter?
well, if it screws up any of the line and then it will cost me a whole lot more, I know ntl can be fecks when it comes down to charging for engineer fees etc if they say its your fault they had to come out. and id rather not risk my connection over sumin im hardly gona use anyhow.
As I said earlier. A splitter isn't even needed to test it.Quote:
Originally Posted by backlash
You don't sound like your ready to experiment with this sort of thing. Maybe you should just drop the whole idea then.Quote:
Originally Posted by feygan
Im ok to experiment when I know abit more, hense the asking. I ready to use p2p software for dubious reasons also but I wasnt until I had a decent friewall etc, caution doesnt indicate non readyness.
if you have the proper adaptor, it shouldn't screw up anything- just go to radio shack or whatever and tell them that you want an adaptor that has the proper end on each end, unhook your modem, thread on the adaptor and plug it into the tv card. all you should need to test is the adaptor. if you happen to have a tv or whatever that has a threaded connector that you could hook up just to see if it's going to work, then you shouldn't even need the adaptor. just plug in something that will receve a tv signal, see if you get cable, and if you do, go shopping for the stuff to hook it up for real.
ok well, when u split a cable modem connection alot of the time it causes problems, they will lose connections randomly and sometimes wont reconnect until you unplug them for like 45 seconds or so and plug them back in...
and it could be possible they block all other frequencies except for the cable internet frequency (900mhz channel 9) Im not sure if its the same frequency there or not
one last thing, Im not sure if your trying to get digital cable even tho they dont have it? but TV tuner cards can only pick up analog, they can only tune to analog and with digital cable recievers they have a MAC number that has to be listed in the cable companies list in order for it to decode the signal, alot of people buy digital cable boxes online and find out they have to be programmed from the cable company in order to decode the signal
anyways I hope that helps a bit, if I remember I might check up on this post later
No problems here, works fine.Quote:
Originally Posted by NoRemoteNoTV
sure they could do that, but unless they ran twice as many lines, then they couldn't do analog cable television, because it would also be blocked for those paying for cable. they could put filters on the lines that block the cable as it goes into the house for those not paying for it, but that's about it.Quote:
Originally Posted by NoRemoteNoTV
Of course you aren't going to get digital cable. however, since the same lines that carry the internet signal also carries the cable, and you don't need to decode the basic cable, they can't really block it out. I have heard that sometimes if there is a filter on the line it sometimes kills the free cable, so I imagion that they sometimes install filters to block the cable signals. the guy installing my internet removed them all when my internet wasn't working right off because sometimes they can block internet signals and cause problems.Quote:
Originally Posted by NoRemoteNoTV
Unplug from the modem and plug into you TV tuner card (or TV).Quote:
Originally Posted by feygan
It should work.
Everyone that has cable TV and internet through the cable company has it split from the main coax coming to the house.
I have it worse than that. I have one coax split into 2 analog, 1 digital, 1 digital HD, and 1 internet feed.
Trust me. It can be split.:ermm: