Quote:
# Maximum and minimum number of peers to connect to per torrent.
min_peers = 40
max_peers = 100
# Same as above but for seeding completed torrents (-1 = same as downloading)
#min_peers_seed = 10
#max_peers_seed = 75
# Maximum number of simultanious uploads per torrent.
max_uploads = 25
# Global upload and download rate in KiB. "0" for unlimited.
download_rate = 0
upload_rate = 0
# Default directory to save the downloaded torrents.
directory = ./torrents
# Default session directory. Make sure you don't run multiple instance
# of rtorrent using the same session directory. Perhaps using a
# relative path?
session = ./session
# Watch a directory for new torrents, and stop those that have been
# deleted.
# schedule = watch_directory,5,5,load_start=/torrent/drop_zone/*.torrent
#schedule = untied_directory,5,5,stop_untied=
# Close torrents when diskspace is low.
# schedule = low_diskspace,5,60,close_low_diskspace=100M
# Stop torrents when reaching upload ratio in percent,
# when also reaching total upload in bytes, or when
# reaching final upload ratio in percent.
# example: stop at ratio 2.0 with at least 200 MB uploaded, or else ratio 20.0
#schedule = ratio,60,60,stop_on_ratio=200,200M,2000
# The ip address reported to the tracker.
#ip = 85.8.2.52
#ip = rakshasa.no
# The ip address the listening socket and outgoing connections is
# bound to.
#bind = 192.168.1.3
#bind = rakshasa.no
# Port range to use for listening.
port_range = 58334-58334
# Start opening ports at a random position within the port range.
port_random = no
# Check hash for finished torrents. Might be usefull until the bug is
# fixed that causes lack of diskspace not to be properly reported.
#check_hash = no
# Set whetever the client should try to connect to UDP trackers.
#use_udp_trackers = yes
# Alternative calls to bind and ip that should handle dynamic ip's.
#schedule = ip_tick,0,1800,ip=rakshasa
#schedule = bind_tick,0,1800,bind=rakshasa
# Encryption options, set to none (default) or any combination of the following:
# allow_incoming, try_outgoing, require, require_RC4, enable_retry, prefer_plaintext
#
# The example value allows incoming encrypted connections, starts unencrypted
# outgoing connections but retries with encryption if they fail, preferring
# plaintext to RC4 encryption after the encrypted handshake
#
# encryption = allow_incoming,enable_retry,prefer_plaintext
#
# Do not modify the following parameters unless you know what you're doing.
#
# Hash read-ahead controls how many MB to request the kernel to read
# ahead. If the value is too low the disk may not be fully utilized,
# while if too high the kernel might not be able to keep the read
# pages in memory thus end up trashing.
#hash_read_ahead = 10
# Interval between attempts to check the hash, in milliseconds.
#hash_interval = 100
# Number of attempts to check the hash while using the mincore status,
# before forcing. Overworked systems might need lower values to get a
# decent hash checking rate.
#hash_max_tries = 10
# Max number of files to keep open simultaniously.
#max_open_files = 128
# Number of sockets to simultaneously keep open.
#max_open_sockets = <no default>
# Example of scheduling commands: Switch between two ip's every 5
# seconds.
#schedule = "ip_tick1,5,10,ip=torretta"
#schedule = "ip_tick2,10,10,ip=lampedusa"
# Remove a scheduled event.
#schedule_remove = "ip_tick1"
# max mem usage
# max_memory_usage = 268435456
max_memory_usage = 768000000
# When the torrent finishes, it executes "mv -n <base_path> ./share/torrents/"
# and then sets the destination directory to "./share/torrents/finished". (0.7.7+)
# on_finished = move_complete,"execute=mv,-u,$d.get_base_path=,./torrents/ ;d.set_directory=./torrents/finished/"
Quote:
afair rtorrent put all file in folder but at the beginning they're 0kb, so the files you disable won't be downloaded. You can also try disable files before first start of a torrent, that should avoid creating them in destination folder (prevent auto starting is the key to all your troubles =])
I really need to know how to disable it then :)
