Printable View
Hey, ive just got a new GPU (8800GT) and ive noticed that the temp compared to my CPU is rather high. The temp on my GPU is 60C and also the the fan is going at 773RPM, is this all normal?
I tried looking through speedfan to see if i could find the fan settings or temp. but speedfan hasnt discovered it yet. so is there a peice of software that will allow me to change the fan speed on my GPU?
New vid cards run much hotter than new CPUs and most stock cooling setups are at best, mediocre.
Installing a Zalman cooler on my 8800GT dropped temps 25°c and since I regulate it's fan with a fanbus, allows for near silent running.
I'd recommend you look into aftermarket coolers for the card.
brillaint will do clocker, i didnt realise that stock fans were so bad compared to aftermarket coolers
where in the UK do they sell GPU coolers and is there a specific model?
Dunno, I'm not in your neck 'o the woods.
Since purchasing mine several new models have come out, so you should just see what's available and go from there.
One thing to note...I noticed that some coolers state that they fit "8800 series" cards.
Be careful as there is a difference in the RAM placement between the GT and GTX versions that may be a problem.
Check out the Arctic Cooling Accelero S1. They are able to run passively allowing for completely silent cooling.
My 8800GT is running at 42C right now with no fan at all. Can't beat that.
The price is also incredible.
60C- kindO' ... high, try new cooler or smth ..
ive got Inno3D 512 8800GT, and it works on 35-40C..
well ive got the same thing as clocker now, Zalman VF- 1000 and it cools it to 31 when idle and 42 when under load.
I think there must have been something wrong with the stock fan. But anyway im much happier with what i have now:)
ya my GeForce 8600 GT runs @ 55c & 70c underload I want to OC it but i need a new fan too for that.
ive only had my GPU for a fews i dont wanna do anything likethat till i know i can replace it:p
8800's are rated at 120c. >80c is pushing the life of your card.
60c is perfectly acceptable. Especially if it's under load. If it's 60c idle look at your case and check out your airflow. if you've got wires all around blocking flow get them out of the way. Any builder will tell you that decent cable management is a good way to keep shit cool. (some builders even charge extra for it :/)
If anything install another case fan. No sense in spending money on an aftermarket cooler if you don't need it (and it won't solve your problem if your case is too hot).
i couldnt agree more with ya about the cable management. i remember with my old tsunami case when i first got it i didnt care about the wires. But then i gave it a good going over and dropped the temps at least 10-15C. Didnt realise it would do that much until i noticed that wires were'nt covering the north and south bridge heat sinks lol.