Printable View
I've been trying to burn .bin files using nero. I first check with cdmage for errors and repair them, then make the cue sheet, follow all the instructions, and nero burns the cd, says everything is fine and then I end up with an unusable cd. where am i going wrong?
Look at this pinned topic. Maybe your slution will be in there.
http://www.klboard.ath.cx/index.php?showtopic=56059
good luck.
Thanks, I had before and followed all the instrutions. my cue sheet looks like this:
FILE "FLT-AM2B.BIN" BINARY
TRACK 01 MODE1/2352
INDEX 01 00:00:00
is that what it should look like?
Well, worst case scenario...you can always open CoasterWorld. ;)
Are you sure the bin files are legit? Try opening with WinISO. Does Nero burn other files OK?
more than likely the bin files are shit..
Yes Nero burns other files fine mp3 and avi etc.. I was able to extract the files with cdmage and then copy them to a cd which seems to have worked. but I still can't burn the bin files normally. I also tried with alcohol 120% and had the same result. I'll try with winISO. thanks
Use alcohol120% again and burn them as RAW DAO mode,sounds like your burning them on the wrong mode.Quote:
Originally posted by dragwell@19 October 2003 - 11:29
Yes Nero burns other files fine mp3 and avi etc.. I was able to extract the files with cdmage and then copy them to a cd which seems to have worked. but I still can't burn the bin files normally. I also tried with alcohol 120% and had the same result. I'll try with winISO. thanks
i think the .bin files are corrupt, and you should just re-download from a different source, rather than spend 2 days screwing around with someting that aint fixable, when you could re-download in less time. its just my opinion and doesnt represent the opinion of others, lol :flowers:
If you downloaded your files with KaZaA++, then it's most likely that they are corrupt. And when burning your files with Nero, select "Burn Image" (I forget where it's located in Nero 6), not CD-ROM.
Yeah I think you're all right and the files aren't good. thanks for the tips
That's probably the problem. I didn't even think of that when I read the original post. You have to quit the wizard and go to File - Burn Image. Then when you select your bin file, a window pops up that let's you set the data mode and block size (or you could just select the cue file if you have one).Quote:
Originally posted by Amarjit@19 October 2003 - 06:48
If you downloaded your files with KaZaA++, then it's most likely that they are corrupt. And when burning your files with Nero, select "Burn Image" (I forget where it's located in Nero 6), not CD-ROM.