I installed a new DVD-R drive, set it to slave, ( I have a CDR) and then plugged in the power and the serial but it did not show up on the PC?
Any ideas?
Printable View
I installed a new DVD-R drive, set it to slave, ( I have a CDR) and then plugged in the power and the serial but it did not show up on the PC?
Any ideas?
reboot
Yes I did that. I double checked to make sure the connections were secure, set as IDE slave. It opens and closes but is not recognized.
It did however fall from lying on its side (when I was putting screws in) to and ended flat on the desk...only about 4-5 inches though.
I have a SATA HDD in case that makes any difference.
It does not show up in the bios as either primary nor secondary device either.
You say you have a CD-R? Is it really set as Master? Maybe they are now both set as Slave. One has to be Master.
Quote:
Originally Posted by Sasage
are you plugging it in as slave with the same ide cable as your cd-r? if you have a cd-r b4, i would think your cd-r is set to slave and connected on the hdd ide cable.
It works now after I went back and triple checked everything.
Thanks!
What was the problem?
The data cable was came undone a little bit. :blush:
Quote:
Originally Posted by Sasage
Shit Happens ! :D