-
Hey. I had my CPU running at 2.2Ghz FINE...but nah..that aint enough.
I have 400Mhz RAM.
I uped the FSB to 420Mhz...and loosend the timings from 2-2-2-5 to 2-3-3-8.
I now have it running at 2.31Ghz and 46C full load right now...
VCore 1.8
Stock heatsink, with an 80mm fan attached to it.
2 intake, 2 exhaust, 2 in the psu, all blue led 80mm fans.
I wonder how high I can get it...
P.S. This is a kinda pointless thread..but I havnt made one in a WHILE...so I just thought what the hell lol
*ALSO*
I have overclocked my graphics card as you can see pretty good. Everytime I turn off my computer and turn it back on..it resets it...its iritating..Im using rage 3d...is this just something we have to do? Or is there a way I can make it stay?
-
Aquamark
Here is my Aquamark3 score after raising the CPU speed over 100Mhz...not much improvment from 40,344.
-
That's quite a nice size OC you got w/ stock cooling!
I have the same processor, but only OC'ed a bit, I'm waiting till I get some Arctic Silver 5 to apply to it, so it doesn't heat up as bad, then I'll OC some more
but good job!
I'm surprised there wasn't more of a difference in scores though...
-
BigDawg,
you might want to alter your memory timings a bit more.
I've read that the nVidia nforce 2 chipset likes the tRAS set to 11 instead of the typical 5 to 8.
I know Mushskin recommends 3+3+2=8 as you have done, but many folks (myself included) get a gain in the memory benchies by using 11 instead.
Something weird to do with the basic architecture of the chipset....
-
alright...ill try 2-3-3-11
-
Ran burn in test overnight and max temp was 46!
I figure I could keep going, up and up and UP. But my ram is 400Mhz... :(
Also, I'm at 420Mhz right now, I'm sure that stresses the chipset alot, and also the ram... :(
-
Did you see any improvements in memory benchmarks with the timing I suggested?
-
i'd like to know about the timings too, ill give it a go soon.
-
I am at school right now and havnt had a chance to change timings at home, but I will put a SS of before my overclock, after my overclock and loose timings, and after the overclock with looser timings (11) If I go to like 230, will that stress my chipset too much or what?
Bells bout to ring for spanish
-
I'm not far behind you.
Currently testing 2.26MHz.
Vcore 1.75V nominal, 1.776 reported.
Vdimm 2.7V
Temp currently 50C and still climbing, I'm not sure I really want to push it much further.