how to hook up a sata via card

[mike160]

hi can anyone can help me out how to remove the back mental to put my sata card on my computer in

[1000possibleclaws]

Instructions

• 
  
  • 1 Buy a SATA card from an online site such as Newegg.com, or at a retailer like Best Buy. A SATA card will use a PCI slot in the computer's motherboard.
    
    
  • 2 Shut down the computer, and unplug it. Place it on a flat surface, such as a table, for easier access.
    
    
  • 3 Remove the side panel of the computer case with a screwdriver.
    
    
  • 4 Locate a PCI slot that can be used for the SATA card. Insert the card into the slot, and secure it by tightening the screw on the faceplate cover.
    
    
  • 5 Attach the data cable from the SATA hard drive to the adapter card. Connect one end of the cable to the hard drive and the other to the SATA card.
    
    
  • 6 Replace the side panel, and tighten the screws. Plug in the computer, and start it up.
    
    
  • 7 Wait for the system to recognize the new SATA card and hard drive. The system will automatically install the software drivers that are needed for the new components.
    
    

Read more: How to Install a SATA Card | eHow.com http://www.ehow.com/how_5121181_inst...#ixzz1QWgMJLye

[mike160]

i get the sata card already just need to know how to put it in

[1000possibleclaws]

Then you've only got 6 steps left

[mike160]

ok thanks done time to flash the 360

just flash the 360 and everthing went well but now when i put in a game it saying reading then open tray and the games wont run

[yevgeny]

You might need to run the iso file through abgx and burn with imgburn. After I flashed the DG-16D4S recently everything was fine with the flash but I didn't use abgx and got an error although I don't recall the tray opening. Did you disable the drivers for the via card like it says in the JungleFlasher guide?

[mike160]

am ok now it was that i did not hook up the 360 dvd drive evething is working now thanks

[1000possibleclaws]

congratz, glad you got it working!