NAV acting up while running Soulseek.

[Skiz]

I still use Soulseek for most of my music downloads, but since upgrading from NAV '03 to NAV '05 I get this pop-up from NAV whenever I use Soulseek. I am using Soulseek 156c btw. When I click OK, the window goes away for a half a sec and another just like it pops up every time. The only info in the window that appears to be dfferent than the previous one, is the Remote Address and the Remote Port. (gotta scroll down to see it) Those numbers change every time. What's the deal with this or how can I stop it?





EDIT: I am currently clicking all the OK's and I must have done a couple hundred of them so far....and still going! WTF?!?

[Samurai]

You need to go into your settings of Worm Protection and find out where Soulseek is located. Select Disable. Reboot. Go back in and Enable. Reboot. Should be fixed

Had this trouble with ASE, but another forum had a thread about this. You need to do it this way

[S!X]

When that happens to me i go into the program control and remove it and re add it and select permit all.

[RPerry]

I had the same problem, and just disabled it all together

[Skiz]

When that happens to me i go into the program control and remove it and re add it and select permit all.

But it's already listed as 'Permit All'.

I may have to do what RPerry said and just disable it, but that makes me a little uncomfortable.

[S!X]

But it's already listed as 'Permit All'.

I may have to do what RPerry said and just disable it, but that makes me a little uncomfortable.

Try what i said, It works for me perfectly. Just delete that one, Then add a new one find the soulseek exe then set it to permit all and your good to go

[Skiz]

Try what i said, It works for me perfectly. Just delete that one, Then add a new one find the soulseek exe then set it to permit all and your good to go

...and there's your answer!

Thx!