........
ok i tried to connect a hd to my old pc but the new ide plug seems to be missing a pin hole and the old ides have an extra pin. you know the one near the center. anyone know anything about this? or maybe should i use the old ide cord to connect to the new hd
Ohh noo!!! I make dribbles!!!
woowoo
It should be standard across all drives.
Are you sure you aren't putting the cable on upside down?
........
nope the 'new' ide plugs are missing a pin
old
new
look its missing a pin hole and i can't fit the new into the old
Last edited by Keikan; 03-27-2005 at 04:55 AM.
Ohh noo!!! I make dribbles!!!
.
Use the old cable.
If the drive was new enough to require an 80-wire cable the pin would be missing. Since it isn't you won't get any benefit using the new cable.
The alternative is to break off the pin - it isn't used anyway - but don't blame me if you damage the drive while you do it.
.Political correctness is based on the principle that it's possible to pick up a turd by the clean end.
Posting Permissions
Reply With Quote
Bookmarks