TRshady
06-26-2004, 03:33 PM
Hey all, am building a pc with a friend, have a new motherboard, processor etc and have set it all up according to the manual though when booting (using the hard drive for my comp I'm using now .. ) .. After choosing to start windows normally I am faced with a flash of a blue screen before a reset. (The blue screen being the error saying that I have recently changed or removed hardware etc or a long line of code with driver erros etc. The flash is too quick for me to note any of it down.)
So my question is .. what steps shall I take to try and solve this?
Edit: Oh, and in case this matters ... heres the specs at the moment:
40gb seagate HDD
256 ddr 2700
Geforce FX5200 128mb
Athlon xp 3000+
K8N Neo Msi Motherboard
ATX case (with 2 usb, mic and speaker port at front with see through side, lights inside etc)
What I think could be the problem is perhaps how the front connecters are set up for audio/usb which is preventing the boot but could be wrong. If anyone has a large picture showing clearly where each connector should go it would be helpful ...
So my question is .. what steps shall I take to try and solve this?
Edit: Oh, and in case this matters ... heres the specs at the moment:
40gb seagate HDD
256 ddr 2700
Geforce FX5200 128mb
Athlon xp 3000+
K8N Neo Msi Motherboard
ATX case (with 2 usb, mic and speaker port at front with see through side, lights inside etc)
What I think could be the problem is perhaps how the front connecters are set up for audio/usb which is preventing the boot but could be wrong. If anyone has a large picture showing clearly where each connector should go it would be helpful ...