When i go into AIDA32 and system in the control panel it says im running a athlon 1600 xp when i have a 1800 xp. What is wrong?
Printable View
When i go into AIDA32 and system in the control panel it says im running a athlon 1600 xp when i have a 1800 xp. What is wrong?
is your fsb setting correct? or your multiplier
Whould resseting my CMOS turn them to default?
No dont reset to default because the mulitplier might be to high at dedault.
check you multiplier as kazaaliterock mentioned.
if you reset it to default, i dont htink that the multiplier would be set too high....i though it was the cpu that determind your multiplier number.
Im guessing the multiplier would be to high because maybe the bios is set for a slower CPU.
But it could automatically adjust it.
Might look into this i would like to know actually :)
What motherboard do you have? maybe it only supports up to an XP 1600+. My shuttle board will only support an XP2400+ but if I overclocked my XP2200+ past the point of it being an XP2400+ it would still only call it an XP 2400+.
You may need to do a BIOS update.Che ck with your mobo manufacturer and see if there is a revision that will make it support different cpu's
My mother board supports more than a 1600 i used to have a 2100 in here and it worked fine.
A 2100+ has showed up as a 2100+?Quote:
Originally posted by Tormentor@3 January 2004 - 23:09
My mother board supports more than a 1600 i used to have a 2100 in here and it worked fine.
Would that be "Mom's" 2100+?Quote:
Originally posted by Tormentor@3 January 2004 - 21:09
My mother board supports more than a 1600 i used to have a 2100 in here and it worked fine.
Why did you switch back?
Ok since no one has any idea of what the hell im talking about here it is, i have the 1800 in my computer now and it only shows it as a 1600. And why mother board supports more then a 1800
I am guessing that your best bet is to go into BIOS and reset your FSB and multiplier setting to whatever a 1800+ is supposed to run.
were can i find what the 1800 is supposed to run at?
Ahh damnit, I wish I would have saved the AMD link I use for the speeds.Quote:
Originally posted by Tormentor@3 January 2004 - 23:35
were can i find what the 1800 is supposed to run at?
Gimme 2 mins and I will go get it for u.
Success!!!! Found the almightly link!
http://139.95.253.214/SRVS/CGI-BIN/WEBCGI....,Case=obj(1224)
I changed a hard drive for a bud set bios to default to auto detect hard drive. Big mistake bumped it from a Duron 1000 gh to a 700 gh Didnt realive my mistake till reboot .I played in the bios with mutipliyer changed 100/ 133 I belive bang back to duron 1000. Gee made me think did the fuking store o/c it ? But working fine